Air Hopper Wheel Replacement: Step-by-Step Fitting Guide

When to replace the Air Hopper wheel

The wheel on your Air Hopper takes a lot of wear, especially if you ride on rough surfaces or use the scooter daily. Over time, you may notice flat spots, cracks, or a wheel that no longer rolls smoothly. If you see these signs, replacing the wheel is a straightforward fix that can restore performance.

Before you order a new wheel, check that the issue is actually the wheel and not something else, like a loose axle or a worn bearing. A quick inspection can save you time and money.

What you get with the replacement wheel

• Parts: Wheel for Air Hopper: Parts: Wheel for Air Hopper is a replacement part from Micro Kickboard, intended for use with the Air Hopper. This listing is for the wheel component only. This confirms the part is designed specifically for the Air Hopper and that you are buying just the wheel, not the axle or other hardware.

  

Step-by-step wheel replacement

These steps assume you have the replacement wheel and basic tools. The exact process may vary slightly depending on your scooter's configuration, so use your best judgment and consult your owner's manual if unsure.

1. 1. Remove the old wheel: Use the appropriate tools to loosen and remove the axle or mounting hardware securing the wheel. Keep all hardware in a safe place for reuse.
2. 2. Clean the mounting area: Wipe away any dirt or debris from the axle and the area where the new wheel will sit. This helps ensure a proper fit.
3. 3. Install the new wheel: Slide the new wheel into place and reattach the axle or mounting hardware. Tighten securely, but avoid overtightening, which could restrict wheel movement.
4. 4. Test the wheel: Spin the wheel to check for smooth rotation and proper alignment. Make sure it spins freely without wobbling.

What to check before you start

Before beginning the replacement, confirm that your Air Hopper model is compatible with this wheel. The listing specifies it is for the Air Hopper, but if you have a different model, check with Micro Kickboard support. Also, ensure you have the right tools for the job—typically a screwdriver or hex key, depending on your scooter's hardware.

If you notice any damage to the axle or bearings while replacing the wheel, address those issues as well to avoid premature wear on the new wheel.

Maintenance tips for longer wheel life

To get the most out of your new wheel, keep it clean and avoid riding over sharp objects or through deep water. Regularly check that the wheel spins freely and that the axle is tight. If you ride often, inspect the wheel for signs of wear every few months.