Micro Kickboard

Parts: Right Side Washer

Parts: Right Side Washer - Main image
$1.88 $2.99 In stock

Category: Scooter Parts

Reduce friction and ensure even pressure between the wheel and the scooter bottom

To install:

  1. First, take off the old wheel. Using two Allen keys, insert one into the square side of the bolt and hold it steady. Insert the second Allen key into the round side of the bolt and rotate counterclockwise to loosen. Remove the wheel.
  2. Remove the screw holding the shank to the scooter.
  3. Remove the washer between the shank and scooter bottom.
  4. Place the new washer between the shank and scooter bottom.
  5. Replace the shank, securing it to the scooter chassis by tightening the screw.
  6. Slide the square side of the bolt into the shank so the round side of the bolt points to the outside of the scooter.
  7. Slide the wheel onto the bolt.
  8. Using two Allen keys, insert one into the square side of the bolt and hold it steady. Insert the second Allen key into the round side of the bolt and rotate clockwise to tighten.

Customer Reviews (4.6 / 5 · 5 reviews)

Andrew ★★★★★

Snapped right in with two Allen keys and the wobble I'd been feeling through the deck is completely gone. The washer sits flush against the wheel and bottom, so the pressure feels even now instead of binding on one side. For a part this small it made a bigger difference than I expected.

Ellie Q. ★★★★★

My wheel was wobbling for weeks until I swapped in this washer, and now it spins smooth with no play at all. Install took maybe ten minutes with two Allen keys, one on the square side of the bolt to hold it steady. Cheap fix that saved me from buying a whole new wheel assembly.

Amelia ★★★★★

Was skeptical a single washer would make a difference until I swapped out the old one and the wheel spin felt noticeably smoother. It sits flat between the wheel and the scooter bottom like it should, so the pressure stays even instead of wobbling. Install took two Allen keys and about five minutes.

Related Products